help with m19 crossover wires

[Altec Best]

You usually get quicker help when you start a new thread.Depending on how old the thread is, the people may not be as active in the forum today..But you can always use these threads for reference.Here's an original diagram of a N1201 which is a Model 19 Crossover...

http://home.earthlink.net/~jmarkwart...1201-8aRev.pdf


BTW Welcome to the forum I see you have been a member since 2007.

[Altec Best]

Your Welcome ! Nicely done John ! I'm curious as to the resistors on each end, where these added later on ? Cause none of mine have those 2 resistors.Looks like 6 resistors on your crossover.AFAIK they only came with 4. 2,3, and 2 3.9 ohm resistors.

[SOOTSHE]

Your Welcome ! Nicely done John ! I'm curious as to the resistors on each end, where these added later on ? Cause none of mine have those 2 resistors.Looks like 6 resistors on your crossover.AFAIK they only came with 4. 2,3, and 2 3.9 ohm resistors.

Ah....well spotted. You're right, these aren't completely stock. I'd forgotten all about these. The resistors are replacing the adjustable L-Pads with a fixed load....sounds much better!